Four Ways to Glue Acrylic Mirror
1. Abutting joint: this is very simple, just need to place the two pieces of acrylic sheets to be connected on the operating platform, glue tape at the bottom after close them, leave a very small gap for the interface, and then inject the paste agent.
2. Bevel adhesive: The bevel adhesive must use a 90 degree Angle against the mold to prevent the displacement of the glued surface. The adhesive should be applied evenly and slowly. The die can only be removed after complete curing.
3. Facade adhesive: facade adhesive is a widely used adhesive technology, first of all, the surface should be wiped clean. It is better to use the die to achieve adhesive, so that the adhesive does not remove, it is beneficial to improve the quality of adhesive. The the acrylic sheet with thickness of 3mm can be pad into the fine metal wire, using the capillary action to complete the adhesive, draw out the metal wire before adhesive curing, or can use adhesive tape, then stick with the method of smearing adhesive.
4. Surface adhesive: flat adhesive is a special adhesive method. First of all, the adhesive surface will be wiped clean, and placed horizontally, inject appropriate adhesive on it. Put one side of another acrylic sheet diagonally in contact with the acrylic plate coated with adhesive, and then put it down evenly and slowly drive out the bubbles from one side to complete the adhesive. (Note: This adhesive will corrode acrylic, protective measures should be taken)
Post time: Mar-31-2022